If the tractor is in the “pull” position, push it down to the “push” position by pinching both tractor position shift levers and rotating the tractors downward. I have the same question How satisfied are you with this reply? Enter or exists the Function mode. Turn the power off, wait a moment, then turn the power on to set top of form. Align the paper horizontally without any slack, by using the mark son the smoked plastic cover as a guide.
|Date Added:||13 October 2004|
|File Size:||12.82 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Then kx-1p124 will be printed in draft mode for approximately 20 minutes. Release the rear lever and continue rotating until the tractor snaps into place.
Advancing the column setting will cause the column indicator light to blink at each alternate choice. I have not been able to use one of these cables on Win 7 yet. Replace the top cover. Pull up the tractors by pinching both tractor position shift levers and rotating the tractor upward. When the [ROW] switch is pressed, the row position will advance sequentially from 1st to 7th.
Unlock the tractors by pulling forward on the tractor clamping levers. I changed to cable to make use of an USP port.
Insert the continuous fanfold paper through bottom slot and pull it up as shown. Turn the power off, wait a moment, then turn the power on to set top of form.
Panasonic KX-P Standard Dot matrix Printer | eBay
Make sure that the head gap lever position is appropriate to the type of paper being used. I had a CPU upgrade to be able to use Windows 7. Sorry this didn’t help. Enter or exists the Function mode. Your cable may not be. You can help protect yourself from scammers by verifying that the contact is a Microsoft Agent or Microsoft Employee and that the phone number is an official Microsoft global customer service number.
The side on which you wish to print should face up. Turn the power off, wait a moment then turn the power on to set top of form. These key switches allow you to select various important features and functions of the printer by setting the Control Table.
To keep the current setting, simply go to a different option. The interface connector is located on the back of the printer towards the left side.
Slide the tractors out towards the sides and raise the tractor covers. Advances to the next row position on the Control Table. Cut sheet feeder Part KX-P Font choices, for example, are prnter this type. The printer allows the user to select the following 14 Initial Setup mode conditions.
Not operational when the Control Table is not in the above mentioned positions If pressed, error sound will occur. Slide the tractors out toward the sides and raise the tractor covers.
Make sure the paper is straight. The column indicator lights C1-C6 shows the current setting for that row.
I have the same question As you lift, release the rear levers, continue lifting until tractors snap into place. Align the center paper support so that it is centered between the tractors. If the tractor is in the “pull” position, printe it down to the “push” position by pinching both tractor position shift levers and rotating the tractors downward.
This releases the paper and allows the paper to be positioned manually as required.